How to make Laptop Audio Amplifier

Usually, the audio output from a laptop’s built-in speakers is low. A power amplifier is required to get a high volume. Here is a simple circuit to amplify the laptop’s audio output.

The circuit is built around power amplifier IC LA 4440 (IC1) and a few other components. LA4440 is a dual channel audio power amplifier. It has low distortion over a wide range of low to high frequencies with good channel separation. Inbuilt dual channels enable it for stereo and bridge amplifier applications.

Laptop Audio Amplifier Circuit
Laptop Audio Amplifier
In dual mode LA4440 gives 6 watts per channel and in bridge mode 19- watt output. It has ripple rejection of 46 dB. The audio effect can be realised by using two 6-watt speakers. Connect pins 2, 6 and ground of IC1 to the stereo jack which is to be used with the laptop.
Assemble the circuit on a general-purpose PCB and enclose in a suitable cabinet. The circuit works off regulated 12V power supply. It is recommended to use audio input socket in the circuit board. Use a proper heat-sink for LA4440.

How to Install:
Install a female 3.5 mm audio jack at the left and right channel of the circuit . with the help of that you can connect any device including laptop to this amplifier using a both side male audio connecting wiregoogle for the schematic of the female 3.5mm audio jack.
credit: EFY
0 Comments
Disqus
Fb Comments
Comments :

0 comments:

Post a Comment